I can't figure out what I am doing wrong!
I have a test project set up as follows:
Frame 1 - the start point with an option to turn Right
Frame 2 - the frame you arrive at from frame 1
- in frame 2 Frame Properties I have inserted the code
Hotspot(2).visible = FALSE
(Hotspot #2 is a picture of a box sitting on a table)
When I travel from frame 1 to frame 2 I see the box sitting on the table. Shouldn't the code in the Frame properties for frame 2 make that hotspot invisible and therefore I should see no box??
I have also tried putting an 'activation' hotspot in frame 2 that I can click on which calls a subroutine that is supposed to make the hotspot invisible, that won't work either (see code below)
Click on the hotspot calls : ChangeHotspotState(HSvalue, HotSpotNumber)
where I have used FALSE for HSvalue and 2 for HotSpotNumber
Subroutine is:
Sub ChangeHotSpotState(HSvalue, HotSpotNumber)
Hotspot(HotSpotNumber).visible = HSvalue
End Sub
I'm using ver 3.5.4 if that is likely to make any difference.
I could sure use some help with this!!!
Skye